OmniHub CMP203– User Manual
Page 25 of 109
Click Reset Counter button to clear continuity count error and restart counting.
Settings tab is used to make the configuration of the input streams. Enter the
destination IP address and destination port, choose protocol (UDP/RTP).
In order to create or edit a larger number of IP inputs, use the Batch Setting
button.
Click the Apply button on the right side to make the change takes effect.
Service Configuration is used to route a whole stream or service/s from the IP input
towards the output channel (stream). Two types of routing are possible:
1. Bypass mode routes whole input transport stream towards output channel.
Bypass mode activation causes output channel will be occupied only by this
To Next Page
Loading...