OmniHub CMP203– User Manual
Page 41 of 109
output the Stream. Put a tick on Multiplex or Bypass on the Channel you want to output.
Do not forget to click the Apply button on the right side to make the change takes
effect.
To use Multiplexing mode on service level click on (pencil) icon. There will have
always a BaseBoard selection for the IP output and other Output option depending on
the module inserted. Select the correct Output and Channel you want to output the
Service. Put a tick on
Multiplex on the Channel you want to output, you can output multiple service in same
channel or output same service in multiple channel. Do not forget to click the Apply
button on the right side to make the change takes effect.
To clear the whole routing table click button.
There is a channel scan button on top, normally the
input service list of each channel will load itself in this page, but when you change the
input source, the list could not refresh immediately. At this time, you should refresh the
changed channels manually through the operation of selecting channel and clicking
Channel Scan button
3.3.5.4 Modules System Operation
System Operation tab allows to perform the following tasks:
- Import / export license
- Log manages
- Reboot
- Factory Default
To Next Page
Loading...