OmniHub CMP203– User Manual
Page 92 of 109
the unicast normally be used, so what should be put in this box is the
management IP address of the CMP203. It is also possible to input a multicast
address (224.x.x.x – 239.x.x.x).
6. Make sure the “Remote Host Port” is configured to be 5050 as this is the default
port for SCTE18 messages and it is not planned to have the CMP203 listen for
SCTE18 messages on any other port.
7. Also make sure the In-Band checkbox is disabled. The CMP203 will be using
the Out-Of-Band PID = 0x1FFC.
8. Another very important configuration is that the Alert Repeat Control must be
set to “Always repeat alert send” and the Alert Message Repeat Period should
be set to 6 seconds.
To Next Page
Loading...