Manufacturer Declarations
TeamConnect | 59
Statements regarding FCC and Industry Canada
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This Class B digital apparatus complies with the Canadian ICES-003.
Changes or modifications not expressly approved by Sennheiser electronic Corp.
could void the user’s authority to operate the equipment.
FCC Part 68 Compliance
US: FBIBR00BINTERACT
Ringer Equivalence Number (REN): 0.0B(ac)
This equipment complies with Part 68 of the FCC Rules Requirements adopted
by ACTA . The mixer unit of this equipment contains, among other information,
a product identifier in the format US:AAAEQ##TXXXX. If requested, this
information must be provided to your telephone company.
The REN is used to determine the number of devices that may be connected
to the telephone line. Excessive RENs on the telephone line may result in the
devices not ringing in response to an incoming call. In most, but not all areas,
the sum of the RENs should not exceed five (5.0). To be certain of the number
of devices that may be connected to the line, as determined by the total RENs,
contact the telephone company to obtain the maximum RENs for the calling area.
The REN for this product is part of the product identifier that has the format
US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal
point (e.g. 03 is a REN of 0.3).
If this equipment causes harm to the telephone network, the telephone company
will notify you in advance that temporary discontinuance of service may be
required. If advance notice isn’t practical, the telephone company will notify the
customer as soon as possible. Also, you will be advised of your right to file a
complaint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations,
or procedures that could affect the operation of the equipment. If this happens,
the telephone company will provide advance notice in order for you to make the
necessary modifications to maintain uninterrupted service.
This equipment uses an RJ11C jack that is used to connect this equipment to
the premises wiring and telephone network. This RJ11C jack complies with the
applicable FCC Part 68 Rules and Requirements adopted by the ACTA. A compliant
telephone cord and modular plug is provided with this product. It is designed to
be connected to a compatible modular jack that is also compliant. See installation
instructions for details.
WARNING:
The country code must be set correctly in Console to ensure that the unit operates
properly when connected to the Telco network, and that it complies with the
country’s Telco requirements. Changing this code to a country other than the
intended country of operation might cause TeamConnect devices to be non-
compliant. 304.
To Next Page
Loading...
