14 Global Settings
Sequential
18. MIDI Param Send: Off, CC, NRPN—Changes to the values of front
panel controls are transmitted via MIDI as Non-registered Parameter
Number (NRPN) controllers or as Continuous Controllers (CC). Trans-
mission of parameters can also be turned off.
NRPNs are the preferred method of parameter transmission, since they cover
the complete range of all parameters, while CCs are limited to a range of 128.
19. MIDI Param Receive: Off, CC, NRPN—Sets the method by which
parameter changes are received via MIDI. As with transmission, NRPNs
are the preferred method.
20. MIDI Control On: Off, On—When On, the synth will respond to
MIDI controllers, including Pitch Wheel, Mod Wheel, Pedal, Breath,
Volume, and Expression.
21. MIDI Sysex On: On, Off—Sets whether MIDI System Exclusive data
will be received or ignored.
22. MIDI Sysex Cable: MIDI, USB—Sets the port, MIDI or USB, by
which System Exclusive data will be transmitted and received.
23. MIDI Out Select: Off, MIDI, USB, All—Sets the port(s) by which
MIDI data will be transmitted.
24. MIDI Program Send: Off, On—When On, the synth will transmit
MIDI Program Change and other SysEx messages to the MIDI Out.
25. MIDI Program Receive: Off, On—When On, the synth will respond
to received MIDI Program Change and other SysEx messages.
26. MIDI Arp Notes: Off, On—When On, the synth’s Arpeggiator outputs
MIDI note numbers. You can use this feature to drive other MIDI-
equipped devices such as synthesizers and drum machines.
27. Arp Beat Sync: Off, Quantize—When set to quantize, Arpeggiator
note playback occurs only on the beat (relative to the current clock divide
setting) regardless of when you press a key on the keyboard.
To Next Page
Loading...
