SEW-Eurodrive MOVI-C Series - Communication Interfaces LAN 1, LAN 3, and VNET

3
Introduction
MOVI-C® CONTROLLER
Manual – MOVI-C
®
CONTROLLER
12
SBUS
PLUS
External PLC
3 x AC 400V
10 min
Power
9007216010041739
3.2.4 Communication interfaces LAN1, LAN3, and VNET
LAN 1
The Ethernet communication interface (LAN 1) is assigned to the Windows
®
section of
the MOVI‑C
®
 CONTROLLER. The interface is only available if the second CFast
memory card with Windows
®
operating system is installed. The following functions can
be realized via this interface:
• Access to the Windows
®
operating system via remote desktop connection
• Connection of a visualization system
• Connection to master level
LAN 3
The Ethernet communication interface (LAN 3) is assigned to the control section (real-
time operating system) of the MOVI‑C
®
 CONTROLLER. The following functions can
be realized via this interface:
• Engineering of the MOVI‑C
®
CONTROLLER
• PC visualization (e.g. OPC interface)
• Connection to master level
Virtual network card (VNET)
The virtual network card (VNET) is only available when the OMW71B/72B Windows
®
memory card is installed. VNET allows you to perform the MOVI‑C
®
 CONTROLLER
engineering via the Windows
®
operating system without LAN 1 cable connection.
22781455/EN – 05/2016