SEW-Eurodrive MOVI-C Series - Startup, Visualization, and Application Examples

5
Project planning and startup with Windows
®
7 Embedded
Startup and visualization
Manual – MOVI-C
®
CONTROLLER
33
5.7.1 Reserved RAM
You can set the size of the reserved memory according to your requirements. Each
write access of a program is routed to this reserved section.
The reserved memory should be large enough to cope with all memory accesses and
small enough to make sure there is sufficient memory left for the correct execution of
programs.
The currently used memory of the reserved section is displayed to allow you to cor-
rectly determine the exact value.
INFORMATION
Do not use the activated "Write protection" function in combination with an activated
Windows
®
swap file.
5.8 Startup and visualization
In order to use the OMW71B/72B Windows
®
memory card as visualization platform,
use the HMI-Builder.PRO software that is included in the MOVISUITE
®
engineering
software. In addition, you require a suitable monitor, such as OPT71C‑120 or OP-
T71C‑150, and the ORV71C USB-dongle to permanently enable the visualization
runtime of the HMI‑Builder PRO software.
INFORMATION
For more information, refer to the "HMI-Builder PRO" manual.
5.8.1 Configuring the Windows
®
section during startup
During startup, you should activate the Windows
®
swap file and deactivate the "Write
protection" menu in the MOVI‑PLC
®
power apps. Due to the Windows
®
swap file, there
is more memory available for applications. Deactivating the "Write protection" menu is
required as otherwise it is impossible to save a changed MOVISUITE
®
project to the
hard drive.
5.8.2 Configuring the Windows
®
section during system operation
Once the system has been started up successfully, deactivate the Windows
®
swap file
and activate the "Set protection" menu in MOVI‑PLC
®
power apps. By deactivating the
Windows
®
swap file, you make sure that the system does not perform unnecessary
write operations on the Windows
®
memory card. Activating the "Write protection"
menu also allows for switching off the supply voltage during operation.
INFORMATION
When switching off the controller, make sure that the system controlled by the control
section is in a safe state.
5.9 Application examples – operation of the Windows
®
section
Application
examples –
operation
of the
Windows
section
The following sections illustrate typical cases for the operation of the Windows
®
sec-
tion.
22781455/EN – 05/2016