SEW-Eurodrive MOVI-C Series - Installation Notes; UHX85 A;UHX84 A Installation Guide

4
Installation notes
MOVI-C® CONTROLLER power UHX85A / power eco UHX84A
Manual – MOVI-C
®
CONTROLLER
15
4 Installation notes
4.1 MOVI-C
®
CONTROLLER power UHX85A / power eco UHX84A
MOVI-C®
CONTROLL
ER power
UHX85A /
power eco
UHX84A
4.1.1 Minimum clearance and mounting position
• The booksize MOVI‑C
®
 CONTROLLER can be installed in the control cabinet.
Leave at least 100mm clearance above and below the unit for optimum cool-
ing. Make sure air circulation in the clearance is not impaired by cables or other in-
stallation equipment.
• Ensure unobstructed cooling air supply and make sure that the
MOVI‑C
®
 CONTROLLER is not exposed to the warm exhaust air from other
devices.
• There is no need for clearance at the sides of the unit. You may connect the
MOVI‑C
®
CONTROLLER and other devices (e.g. MOVIDRIVE
®
modular) in series.
• Install the units vertically only. You must not install them horizontally, tilted or up-
side down.
22781455/EN – 05/2016