SEW-Eurodrive MOVI-C Series - Replacing the Unit; Unit Replacement Procedure

6
Replacing the unit
Manual – MOVI-C
®
CONTROLLER
42
6 Replacing the unit
For replacing a controller, a compact controller, or a controlled drive, follow the in-
structions in the "Installation" chapter. Insert the CFast memory card of the previous
controller into the new controller.
INFORMATION
The variable values stored remanently on the controller are not stored on the CFast
memory card by default. This can be programmed through the application (IECpro-
gram), or the data backup must be imported through the project management in
MOVISUITE
®
.
For information on replacing the drives, refer to the manual of the respective inverter.
22781455/EN – 05/2016