SEW-Eurodrive MOVI-C Series - Connection to Ethernet Communication Interfaces; Connecting USB Interfaces; DVI-I Interface Connection

4
Installation notes
MOVI-C® CONTROLLER power UHX85A / power eco UHX84A
Manual – MOVI-C
®
CONTROLLER
20
4.1.6 Connection to Ethernet communication interfaces
You can use the Ethernet communication interfaces LAN1 and LAN3 to connect an
engineering PC or other network stations (e.g. visualization systems). The Ethernet
communication interface LAN 1 is only available in combination with the OM-
W71B/72B Windows
®
memory card.
PC COM
LAN1/LAN3
14344512395
4.1.7 Connecting USB interfaces
The USB interfaces USB1, USB2, USB3, USB6 and USB7 are assigned to the
Windows
®
operating system (OMW71B/72B option). You can use those USB inter-
faces to connect a keyboard, a mouse or a touchpad. The USB interfaces USB4 and
USB5 are assigned to the MOVI‑C
®
CONTROLLER.
4.1.8 DVI-I interface connection
The DVI-I interface assigned to the Windows
®
operating system (OMW71B/72B op-
tion) is used for connecting a monitor to the MOVI‑C
®
CONTROLLER.
SEW‑EURODRIVE recommends the connection of the following monitors:
• OPT71C-120 (part number 1797 428 3)
12 inch touchscreen with a resolution of 1280×800
• OPT71C-150 (part number 1797 429 1)
15 inch touchscreen with a resolution of 1280×800
22781455/EN – 05/2016