SEW-Eurodrive MOVI-C Series - Using an On;Off Button on X1; Procedure after a Unit Replacement; Restoring the Delivery Condition

5
Project planning and startup with Windows
®
7 Embedded
Procedure after a unit replacement
Manual – MOVI-C
®
CONTROLLER
31
5.3.2 Using an on/off button on X1
You can use terminal X1 on the controller to connect an on/off button for the controller.
The button works like a PC on/off button.
• Press the button briefly to switch the controller on or off during operation.
• Press the button for at least 5seconds to switch off the controller.
If you have switched-off the controller via the button, you also have to use the but-
ton to switch the controller back on.
Wiring diagram – button on X1
On M -24+
DC24V
X1
7917280395
5.4 Procedure after a unit replacement
You can use the normal Windows
®
programs to create a backup image of the OM-
W71B/72B Windows
®
memory card. SEW‑EURODRIVE strongly recommends creat-
ing a data backup.
5.5 Restoring the delivery condition
You can download a recovery image from the software section on the SEW website to
restore the delivery condition of the software package. The recovery image is de-
signed to prepare a USB stick for the installation.
22781455/EN – 05/2016