SEW-Eurodrive MOVI-C Series - Remote Desktop Connection

5
Project planning and startup with Windows
®
7 Embedded
Application examples – operation of the Windows section
Manual – MOVI-C
®
CONTROLLER
34
INFORMATION
• SEW‑EURODRIVE provides the non-exhaustive application examples as a gen-
eral reference and does not assume corresponding liability.
• SEW‑EURODRIVE does not offer support for setting up your Windows
®
system.
5.9.1 Remote desktop connection
You can use the remote desktop connection in Windows
®
for remote maintenance pur-
poses. Note that remote maintenance does not allow you to monitor the state of the
system on-site.
Proceed as follows:
1. Make sure that there is a network connection between your computer and the
Windows
®
section of the controller.
2. Make sure that you use a password-protected user account when you work with
the controller.
3. Activate the remote desktop connection on the controller. To do so, open the
Windows
®
Control Panel (see the following figure).
7829376267
22781455/EN – 05/2016