EasyManua.ls Logo

SEW-Eurodrive MOVI-C Series - Memory Card Options

SEW-Eurodrive MOVI-C Series
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
Introduction
CFast memory card OMH85A (card slot 1)
Manual – MOVI-C
®
CONTROLLER
13
3.2.5 EtherCAT
®
/SBus
PLUS
interface LAN 2
You can connect up to 64 of the following units to the MOVI‑C
®
CONTROLLER via the
EtherCAT
®
/SBus
PLUS
interface:
MOVIDRIVE
®
modular drive inverter
MOVIDRIVE
®
system drive inverter
MOVI‑PLC
®
I/O system C
Third-party components with ETG configuration file
3.2.6 Engineering
The engineering of the MOVI‑C
®
CONTROLLER comprises the following activities:
Configuration
Parameterization
Programming
Engineering is carried out using the MOVISUITE
®
engineering software. The software
has a number of useful features for startup and diagnostics of all connected
SEW‑EURODRIVE units. The connection between the MOVI‑C
®
CONTROLLER and
the engineering PC is carried out via the Ethernet communication interface (LAN 3).
3.3 CFast memory card OMH85A (card slot 1)
The CFast memory card (CompactFlash ATA Serial Transfer) is required for operation
of the MOVI‑C
®
CONTROLLER and contains the firmware, the IEC program and user
data (e.g. recipes). You can use the memory card for data backup and automatic pa-
rameterization in the event of an axis replacement. The CFast memory card OMH85A
is plugged into card slot 1 of the MOVI‑C
®
CONTROLLER.
3.4 Windows
®
memory card option OMW71B/72B (card slot2)
Windows
memory
card option
OMW71B/7
2B (card
slot2)
3.4.1 Features
The Windows
®
memory cards OMW71B (16GB) and OMW72B (32GB) are designed
as CFast memory cards. It extends the MOVI‑C
®
CONTROLLER by a Windows
®
plat-
form and can be used for plant visualization. The Windows
®
memory card OM-
W71B/72B is plugged into card slot 2 of the MOVI‑C
®
CONTROLLER.
The Windows
®
memory card OMW71B/72B contains the operating system Windows
®
7 Embedded in English.
The MOVI‑C
®
CONTROLLER provides the following hardware for the Windows
®
sys-
tem:
Core2Duo 2.2GHz (Windows
®
7-Embedded merely uses 1 core)
1.5GB RAM
5 ×USB 2.0 (USB 1, 2, 3, 6, 7)
Windows
®
7-Embedded 32 bit
1 ×Ethernet 10/100MBaud (LAN 1)
1 ×virtual Ethernet to the control section
22781455/EN – 05/2016

Table of Contents

Related product manuals