Sharp AM-400

Installing the Software
30
Comments:
♦ Do not connect the AM-400 to a hub to which another AM-300/AM-400 is
connected. If this is done, the AM-400 will not operate correctly.
♦ If you find that your computer does not recogize the machine or operation is
unstable, try connecting the USB cable to a different USB port on your
computer, or try a different USB cable (use the shortest possible cable).
11. Plug in the power cord of the machine.
♦ Windows
®
XP: Go to the procedure for completing installation of the
software on Windows XP below.
♦ Windows
®
2000: This completes the installation of the software.
Note: If a warning message regarding the Windows logo test appears (the
warning may appear twice), click Yes each time the window appears. This
will complete the installation of the software.
♦ Windows
®
Me: This completes the installation of the software.
Completing installation of the software on Windows
®
XP
12. In Windows
®
XP, the Found New Hardware Wizard will appear. Make sure
that Install the software automatically (Recommended) is selected and
click Next (this will install software for using the machine as a scanner).