Selecting Temporary Copy Settings
56
If MEMORY IS FULL appears...
If the memory becomes full while multiple originals are being scanned using
the auto document feeder, MEMORY IS FULL will appear in the display.
♦ Press if you want to make copies of only the originals that have
already been scanned. The remaining originals will be ejected from the
feeder.
♦ Press if you want to cancel the copy job.
Selecting Temporary Copy Settings
You can adjust one or more of the following temporary copy settings before
pressing to begin copying.
Enlarge/reduce
Press one or more times until the desired enlargement or reduction
percentage appears in the display. The preset percentages are 100%, 78%,
64%, 50%, 25%, 400%, 200%, and 129%.
♦ After selecting one of the above preset percentages, you can also press
or to increase or decrease the percentage in increments of 1%.
The maximum percentage is 400% and the minimum percentage is 25%.
When the desired percentage appears, press the key.
Example: Press 3 times and then to select 64%
ZOOM
Z
A
ENTER
ZOOM
ENTER
COPY RATIO: 64%
64% A4 01
To Next Page
Loading...
Need help?
General
