Sending a Fax
71
3. Sending
Faxes
Using the REDIAL key
When sending a fax, you can also automatically redial the last number
dialled by the machine. Follow the fax sending procedure on the previous
pages. In Step 4, press , make sure the number that appears in the
display is the number you wish to dial, and then press . Scanning of
the originals will begin (see Step 6).
REDIAL
If the memory becomes full...
If the memory becomes full while the document is being scanned, MEMORY
IS FULL will appear in the display.
♦ Press if you want to transmit the pages which have been stored up to
that point in memory. If you are using the auto document feeder, the
remaining pages will feed out without being scanned. After transmission,
the memory will be cleared and you can transmit the remaining pages. You
will also need to transmit the page which was being scanned when the
memory filled up.
♦ Press if you want to cancel the entire transmission.
• If the transmission is completed successfully, the machine will beep once.
• If an error occurs, the machine will beep three times and print a
Transaction Report to inform you of the problem (see page 130).
To Next Page
Loading...
Need help?
General
