AR-5726/5731 FIRMWARE UPDATE 9 - 2
6) When downloading copier firm, expand "Special(Copier)", and
double-click on "All Data areas Download".
7) Select download file(*.dat), and press "Open" button.
8) Download procedure starts automatically.
9) Notice message "Download is complete. Check the copier panel
to make sure the download is complete." will appear on PC.
10) Close the maintenance program, and turn off the copier. Turn on
the copier again after pulling the plug.
This is the end of download procedure.
∗ It is possible that download process somehow went wrong if the
copier does not start up properly. In that case, start up the copier
and maintenance program in download mode by repeating the step
1)-5) again. And then, Expand "Special", and double-click on "Con-
firm Error Status". If any of the message besides "No error has been
occurred" appears, it means that download is incomplete, so please
try again.
To Next Page
Loading...
