Sharp DX-C200P - 3 Other Print Operations; If a Paper Mismatch Occurs; Performing Form Feed; Canceling a Print Job

3. Other Print Operations
If a Paper Mismatch Occurs
Use the form feed function to continue printing when a paper size or paper type error occurred.
This function can be performed using the control panel.
• If the [Auto Continue] setting under [System] is enabled, the printer ignores the paper type and size
settings and prints on whatever paper is loaded. Printing stops temporarily when the error is
detected, and restarts automatically after about ten seconds using the settings made on the control
panel.
• For details about [Auto Continue], see p.57 "System Menu".
Performing Form Feed
Use the following procedure to perform form feed.
1. While an error message is displayed on the control panel, press the [Stop/Start] key.
Printing starts.
• If you want to print after adding paper to the tray, load the correct paper, and then press the
[Stop/Start] key.
• If a tray with a smaller paper size is selected, the print job may be cut short, or other problems may
occur.
Canceling a Print Job
Use the following procedure to cancel a print job that is related to the printer error occurred.
1. Press the [Job Reset] key.
2. Press the [OK] key.
19