Trap
Item Description
Target Trap Select whether to enable the printer to send traps to the management host
(NMS). When set to [Inactive], [SNMP Management Host 1] and [SNMP
Management Host 2] below become unavailable.
SNMP Management
Host 1
Enter the IP address or host name of a management host. Can contain up to
64 characters.
SNMP Management
Host 2
Enter the IP address or host name of a management host. Can contain up to
64 characters.
Community
Item Description
Get Community Enter the community name to use for authentication of Get requests. Can
contain up to 32 characters.
Trap Community Enter the community name to use for authentication of Trap requests. Can
contain up to 32 characters.
System
Item Description
Location Enter the location of the printer. The location entered here is displayed on
the main page. Can contain up to 64 characters.
Contact Enter the contact information of the printer. The contact information entered
here is displayed on the main page. Can contain up to 64 characters.
Configuring the SMTP Settings
Click the [SMTP] tab on the network settings page to configure the SMTP settings.
6. Monitoring and Configuring the Printer
92
To Next Page
Loading...
Need help?
General
