Auto Continue
Sets the printer to ignore an error with paper size or type and continue printing. The printing stops
temporarily when an error is detected, and restarts automatically after about ten seconds using the
settings made on the control panel.
However, even if you set to [On] and certain errors occur, the current job may be canceled, and
the printer automatically performs the next queued job.
Default: [Off]
• Off
• On
Copies
Specifies the number of pages to print.
This setting is disabled if the number of pages to print is specified by command or the printer driver.
Default: "1"
• 1 - 999
Sub Paper Size
Sets the printer to print onto paper of another size if the specified paper is not loaded in any tray.
Alternative sizes are preset to A4 and Letter.
Default: [Off]
• Off
• Auto
Duplex
Sets the printer to print on both sides of paper according to the specified binding method.
Default: [Off]
• Off
• Short Edge Bind
• Long Edge Bind
Blank Pg. Print
Sets the printer to print blank pages.
When cover sheet printing is enabled from the printer driver, cover sheets are inserted even if you
select [Off].
Default: [On]
• On
• Off
5. Making Printer Settings Using the Control Panel
58
To Next Page
Loading...
Need help?
General
