Sharp ER-A420 - Selection of X1;Z1 and X2;Z2 Reports to be Printed in the Stacked Report Sequence 2620

131
Selection of X1/Z1 and X2/Z2 reports to be printed in the stacked report
sequence
Your register is equipped with the stacked report printing function that enables multiple X/Z reports to be printed
in sequence with only a single request.
• A maximum of 70 steps are programmable. “1 step” means the memory size used for one no-
range type job no. The range type job no. needs “8 steps”.
• When the Z of stacked report is initiated, X only reports will be skipped.
Job code numbers to be used are as follows.
*3: Both range setting and full setting are allowed.
To print reports 10 and 13 as a stacked report.
2620
.@
10
ı
13
ı
a
PrintKey operation
Example
00
10
13
20
24
27
29
30
31
32
50
60
70
80
*1: Job no. Report name
*2: Start/End range parameter
Note
General
Full department
Full department group
PLU/UPC
PLU/UPC stock
PLU/UPC zero sales
PLU/UPC price category
Transaction
Cash in drawer
Commission sale
Full cashier
Hourly sales information
Daily net report
PBLU report
*3 Start code/End code (max. 5/13 digits)
*3 Start code/End code (max. 5/13 digits)
*3 Start price amount/End price amount
*3 Start time/End time (0 thru 2330)
*3 Start PBLU code/End PBLU code (1 thru 9999)
Range report is available
only in the X1 mode.
Note
2620
.
@
@@
s
a
Job no.
Start range
parameter
For full reporting (non-range report)
To cancel the stacked report sequence
To program any Job no.
*1
*2
For individual reporting
End range
parameter
*2
Procedure
2620
PGM 2
ER-A410/A420(SEC)-4 03.12.22 0:20 PM Page 131