178
Data Communication
When using Android Beam
z
Use while placing the # mark of the receiver's device over that
of the sender's device as shown.
z
Do not move the devices until sending and receiving of data are
completed.
z
There may be some cases in which data are poorly sent and
received or the display is turned off by positioning a device near
depending on the other party's device. In this case, put a
distance between the # marks apart/closer or move them up/
down or to the left/right.
z
Other precautions are the same as those for when you hold the
handset over the other device (
☞
P. 110 “Precautions about
holding over the other device”).
Sending data
Example: Phonebook
1
In the home screen, select “ドコモクラウド”
(docomo cloud) folder▶[docomo phonebook]
▶[Contacts]
2
Select a name
3
Place the # mark over that of the other party's
device
z
[Tap to beam] appears.
4
Touch the screen
Receiving data
1
Place the # mark over that of the other party's
device
To Next Page
Loading...
