206
Appendix/Index
1. Reorient/relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for
help.
FCC RF Exposure Information
Your handset is a radio transmitter and receiver.
It is designed and manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government.
The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough
evaluation of scientific studies. The standards include a substantial
safety margin designed to assure the safety of all persons,
regardless of age and health.
The exposure standard for wireless handsets employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The
SAR limit set by the FCC is 1.6
W/kg.
This device is granted with two kinds of FCC ID depending on the
production month and each highest SAR values are shown in the
table below.
The use of accessories that do not satisfy these requirements may
not comply with FCC RF exposure requirements, and should be
avoided.
The FCC has granted an Equipment Authorization for this model
handset with all reported SAR levels evaluated as in compliance
with the FCC RF emission guidelines. SAR information on this
model handset is on file with the FCC and can be found under the
Display Grant section of
(
http://transition.fcc.gov/oet/ea/fccid/
)
after
searching on the corresponding FCC ID (see the table on the left
bottom).
Additional information on Specific Absorption Rates (SAR) can be
found on the FCC website at
(
http://www.fcc.gov/encyclopedia/
radio-frequency-safety
)
.
FCC ID Location
The device is electronically labeled and the FCC ID can be
displayed via the About phone & the Authentication under the
Settings menu.
Export Administration Regulations
The Japan Export Administration Regulations (“Foreign
Exchange and Foreign Trade Act” and its related laws) may be
applied to this product and its accessories under certain
conditions. The Export Administration Regulations may also
be applied. To export or reexport the handset and its
accessories, conduct all legally required procedures at your
own risk and expense. For details on the procedures, contact
the Ministry of Economy, Trade and Industry or the US
Department of Commerce.
For body worn operation, this phone has been tested and meets
the FCC RF exposure guidelines. Please use an accessory
designated for this product or an accessory which contains no
metal and which positions the handset a minimum of 1.0 cm from
the body.
FCC ID
APYHRO00251
At the Ear
0.55 W/kg
On the Body
0.69 W/kg
APYHRO00254
0.37 W/kg
0.59 W/kg
To Next Page
Loading...
Need help?
General
