Sharp XE-A207B

106
SDCARDMode
The register’s data can be saved to the SD memory card, and the programming data can be loaded from the
SD memory card.
To use the SD card function, select the “SD CARD” mode in the mode selection window and perform the
following operations.

■
InsertingandremovinganSDmemorycard
The SD card slot is located on the front side of your register.
InsertinganSDmemorycard
Insert an SD memory card into the SD card slot with the printed
SD logo facing upwards. Push the card in steady with a nger until
it clicks and release it slowly.
RemovingtheSDmemorycard
Push the card in gently with a nger and release it. The card will
come out.
NOTE
• This model supports SD cards only. Use of any other types of SD cards such as mini SD, micro SD, etc.
with an adapter is not supported.
• When inserting or removing the SD memory card, be sure to release it slowly. Otherwise, the card may pop
out and injure your nger.
• Never touch or remove the SD memory card while it is accessed, otherwise the data stored in it may be
damaged.
• Formatting the SD memory card erases all the data in it.

■
SDcardformatting
When the SD card is not formatted yet, take the formatting operation.
Procedure
(1) Select “4 FORMATTING” in the SD CARD mode, the conrmation window is displayed.
(2) To perform the format operation, select OK and press the
A
key.
To cancel the operation, select CANCEL and press the
A
key.

■
Foldernameselecting
The programmed code is used the le folder structure. Up to 8 digits code can be programmed.
Procedure
(1) Select “3 FOLDER CONTROL” in the SD CARD mode, the FOLDER CONTROL window is displayed.
(2) Select “2 SELECT FOLDER”, the folder code list window is displayed.
(3) Select the required folder name from the list, and enter the
A
key.
To cancel the operation, press the
a
key.