Sharp XE-A207B

51
8
Reading(X)andResetting(Z)
ofSalesTotals
• Use the reading function (X) when you need to take the reading of sales information entered
after the last resetting. You can take this reading any number of times. It does not affect the
register’s memory.
• Use the resetting function (Z) when you need to clear the register’s memory. Resetting prints all
sales information and clears the entire memory except for the GT1 through GT3, reset count,
and consecutive number.
• X1 and Z1 reports show daily sales information. You can take these reports in the X1/Z1 mode.
• X2 and Z2 reports show periodic (monthly) consolidation information. You can take these
reports in the X2/Z2 mode.
• In the OP X/Z mode, an clerk can take his or her report.
• If you want to stop the printing report, press the
a
key.

■
HowtotakeaX1/Z1orX2/Z2report
[TotakeanX1orX2report:]
1.
Press the
j
key.
2.
Select the “4 X1/Z1 MODE” or “5 X2/Z2 MODE” by using the
I
key, and press the
A
key.
3.
Select “2 READING” in the X1/Z1 mode or select “1 READING” in the X2/Z2 mode menu window to
display the items list.
4.
Select the appropriate report title.
5.
Press the
A
key.
[TotakeaZ1orZ2report:]
1.
Press the
j
key.
2.
Select the “4 X1/Z1 MODE” or “5 X2/Z2 MODE” by using the
I
key, and press the
A
key.
3.
Select “3 RESETTING” in the X1/Z1 mode or select “2 RESETTING” in the X2/Z2 mode menu
window to display the items list.
4.
Select the appropriate report title.
5.
Press the
A
key.

■
Flashreport
You can take ash reports (display only) in the X1 mode for department sales, cash in drawer (CID) and
sales total at the point you take the report.
1.
Press the
j
key.
2.
Select “1 FLASH READ” in the X1/Z1 mode menu window to display the items list.
3.
Select “DEPT. SALES” to take a ash report of department sales, “CID” to take a ash report of cash
in drawer, or “SALES TOTAL” to take a ash report of sales total.