Sharp XE-A207B

119
c
EUROMigrationFunction
Basically your register can be automatically modied to correspond to the introduction of EURO by executing
the operation “EURO STATUS” in X2/Z2 mode. However, there are several options you must set depending
on your need. So, please carefully conduct necessary settings.
EUROstatus:
You can select status from following 4 types ((A), (B), (C), or (D)). And the selectable type is decided as
follows for each status. Type (A) is the base status (initial status).
From type (A) ———— selectable
Type (B), (C), or (D)
From type (B) ———— selectable
Type (C), (D)
From type (C) ———— selectable
Type (D)
Items Type(B) Type(C) Type(D)
General Z1 report ISSUE ISSUE ISSUE
General Z2 report ISSUE ISSUE ISSUE
GT1/GT2/GT3 memory — CLEAR CLEAR
Exchange1 amount printing for total and change YES YES NO
Exchange1 calculation method DIVISION MULTI MULTI
Domestic currency symbol — [EURO] [EURO]
Domestic TAB — 2 2
Conversion of preset prices of Dept./PLU* — YES YES
Exchange1 currency descriptor [EURO]
The current
domestic
currency symbol
—
Exchanger1 TAB 2
The current
domestic TAB
—
The marked items “—” is remaining the current data.
*: The preset rate of the Exchange1 is applied as the conversion rate, and the calculation method is set to
“division”. When the conversion has been made, the message “PRICE CONVERTED” is printed on the
report.