Sharp XE-A207B

120
SettingthedateandtimewhentheautomaticEUROmodicationoperationshouldbeexecuted
To certainly execute the automatic modication operation, you can program the scheduled date and time to
execute the automatic EURO modication operation. From ten days before the preset date, the remaining
days are printed at the bottom of the daily full resetting report.
Date and time setting will be reset after the execution of automatic modication operation, and again you
can program the date and time for the next automatic modication operation.
Also you can make the automatic EURO modication operation compulsory. When the above-mentioned
preset date and time has come, and also when you start an entry in the REG/MGR mode, the error message
“EURO CHANGE ENTRY COMPULSORY” will be displayed. You cannot start any operation in the REG/
MGR mode until you make the operation.
AutomaticEUROmodicationoperation
1. Select “5 X2/Z2 MODE”.
2. Select “3 EURO STATUS” from the menu.
3. Select the status you want to set (B, C or D) referring to the table on the previous page. Press the
P
key to toggle the options.
Please note that once you set a status, you cannot return to the previous status(es).
Importantnote
As for the miscellaneous keys, such as
J
and
¡
keys, and for the HALO setting, the automatic
conversion will not be made. You need to change the % rates or amounts in the PGM mode after the
execution of the automatic modication operation for EURO so that they are based on amounts in
EURO.
NOTE
It is executed some of following operation which is needed for each status.
(1) Issue general Z1 report. (2) Issue general Z2 report. (3) Clear GT1/GT2/GT3. (4) Change
PGM function “Total and change amount printing — With foreign/Domestic only”. (5) Change
PGM function “Exchange1 calculation method — Division/Multiplication”. (8) Change PGM
function “Converting the preset unit prices of departments/PLUs to the ones in EURO currency
- YES/NO. (9) Set “Exchange1 currency descriptor” as the suitable data. (10) Set “Exchange1
TAB” as the suitable data.
NOTE
This job cannot set the following additional EURO function. You must set the following items by
each programming after executing the automatic EURO modication operation.
1) Exchange1 rate, (2) “Check, Credit operation for Exchange1 — YES/NO”
Also when you are using any of the Exchange2, you must change the rate.