iv
263-13228
○ Explanation of label
(1) HOT SURFACE : Risk of burn. (Notes 1)
・ Keep off from touching surface of the pump as it is
heated.
・ Keep off from touching upper side surface of the
power supply while the pump is in deceleration as it is
heated.
(2) Do not remove cover, or else it may cause some
changes inside and it is failed.
(3) Do not shut off ventilation, or else the inside of
power supply get heated and it is failed.
(4) Be sure to use specified cable for this power supply.
If not, it may cause connector be broken and power
supply itself failed.
(5) SECURITY seal
This label certificates that the product was made or
maintenanced by Shimadzu or by Shimadzu
authorized facility.
In case "this label is removed" or "there is a mark
showing once this label has been removed",
Shimadzu warranty shall not be applied to the
product.
(Notes 1) The power supply units for some production lots come with a single nameplate, on
which the name is indicated in both English and Japanese, whereas the power supply units
for other production lots come with two nameplates, one in English and one in Japanese.
○ Location of label
CAUTION
！
高温注意
HOT SURFACE
Risk of burn. Avoid contact.
やけどのおそれがあります。触らないで下さい。
！
CAUTION
DO NOT REMOVE COVER.
ケースを分解しないでください。
！
262-76048
USE SPECIFIED CABLE ONLY.
指定のケーブルを使用してください。
CAUTION
！
262-76050
DO NOT SHUT OFF VENTILATION.
通風口をふさがないでください。
CAUTION
！
262-76049
(3)
(2)
(4)
(1)
(2)
(same on reverse side)
(5)
To Next Page
Loading...
