Shimadzu EI-D3203M - Compatibility with Previous Models

5.1 Installation of the Power Supply Unit
21
Power Supply Unit
INSTRUCTION MANUAL
5
5.1.3 Compatibility with Previous Models
If previous EI-xx03M/MD/MZ power supply units (where "xx" is a number that indicates the
applicable pump type) are being used installed on a rack, then optional rack mounting kit is
required in order to replace these units with EI-Dxx03M power supply units.
The mounting screws are to be supplied by the customer.
Prepare the shelf to support the weight of the power supply unit in the rack.
Optional Parts (Rack Mounting Kit)
How to install the unit onto the rack :
(1) Turn the power supply unit over and remove the four rubber pads.
(2) Attach the rack mounting panel to the power supply unit with four Panel Attachment
Screws. (See Fig. 5-7)
(3) Reattach the rubber pads of the power supply unit if they are necessary.
(4) Fix to the rack using 4 M4 tap screws. (See Fig. 5-7, Fig. 5-8)
Fig.5-6 Dimensions of Rack Mounting Panel
Description Q’ty Notes Parts Number
1
Rack Mounting Panel 1
Steel, painted same color as
front panel of power supply
unit. (See Fig.5-5)
263-14117
2
Panel Attachment Screws 4 Stainless Steel, M4 L=6mm
φ5 HOLE,
4 PLACES
M4 TAP, 4 PLACES
213
20.5
172
5
1
8
9
1
9
9
5 203
7.5 198.1
122.5 114.5
4-M4
4－φ5穴
4
t2.3
長角穴
Opening
21.3
Ｃ
１
（
４
か
所
）
1
x
4
5
°
(
4
P
L
A
C
E
S
)