Shimano STEPS E6000 - Before Your First Ride; Attaching the Pedals

EN-14 Original User Guide | Pedelec Shimano Steps E6000 Version 1
3.1 Attachingthepedals
1. Screw the right-hand pedal (marked ‘R’) into the right-hand pedal
crank in a clockwise direction.
2. Screw the left-hand pedal (marked ‘L’) anticlockwise into the left-hand
pedal crank.
DANGER
Screwthepedalsinstraight,otherwise you could damage the thread
on the pedal crank; if this happens when you are cycling, a severe fall
could result.
3. Tighten both pedals towards the front wheel to a torque of 40 Nm.
3. Beforeyourrstride
Make sure that your pedelec is adjusted to your height and ready to use.
Familiarise yourself with the basic functions of your pedelec.
DANGER
Askyourcycledealertoshowyouhowtouse,andexplain,thespecial
featuresofthepedelecanditscomponents.Pleasealsofollowthe
componentguides.Werecommendhavingyourcycledealerperform
allassemblyandadjustmentwork.Otherwise, components could
become loose due to a faulty assembly. If this happens whilst you are
cycling, you could injure yourself very seriously or even die. If you do
have to tighten something yourself, a full list of torque settings is in
Section  8. Torque settings Page EN-46 (strict adherence to which is a
requirement).
Adjustthepedelectoyourheight.If the bike is not correctly adjusted
to your height, you can lose control of the bike and fall badly.
Practisebrakingandridingwiththeassistfunctioninasafeplace
beforeventuringintotrac.If you do not familiarise yourself with the
operation and higher speed of your pedelec, you could cause a serious
accident. Ride in ECO mode until you feel condent enough to try the
higher modes. Dismount if you ever feel unsafe.