Shimano STEPS E6000 - Braking

Original User Guide | Pedelec Shimano Steps E6000 Version 1 EN-19
3.4 Adjustingthesprungseatpost
DANGER
It is best to ask your cycle dealer to adjust the suspension elements of
the seatpost.
1. Remove the seatpost.
2. Tighten the suspension adjustment screw with an Allen key (6 mm
AF) in the clockwise direction to reduce the suspension or loosen
anticlockwise to increase the suspension.
DANGER
Thesuspensionadjustmentscrewmustnot
protrudefromtheseatpost,otherwise the
screw/seatpost can loosen – if this happens
while riding you could fall o, resulting in
serious injuries.
Suspension
adjustment
screw
Screw must not protrude
from the seatpost
3.5 Adjustingtheheightandangleofthehandlebars
DANGER
Askyourcycledealertoperformtheseadjustments.You can otherwise
run the risk of loosening the handlebars which could lead to a fall
causing severe injuries.
3.6 Switchingthelightsonando
*
A slider control is located on the rear of the front light. Depending on
which way you move it, the front and rear light will be on or o when you
are riding.
3.7 Braking
Make sure that you can always reach the brakes comfortably and that you
are familiar with their operation and position. Note which brake lever
operates the front and rear brakes. If your pedelec is tted with a back
pedal or coaster brake, you can operate it by pedalling backwards.
*dependent on model