Shimano STEPS E6000 - Rims

EN-26 Original User Guide | Pedelec Shimano Steps E6000 Version 1
Quick-releaseskeweristooeasyto
close
1. Open the quick-release skewer.
2.
Hook the quick-release skewer into the
slot and turn it clockwise. This will screw
the axle in the thread. Make sure that
your wheel is correctly centred.
3.
Close the quick-release skewer.
4.
Repeat if necessary.
Quick-releaseskewerisnoteasyto
close
1. Open the quick-release skewer.
2.
Hook the quick-release skewer into the
slot and turn it anticlockwise until the
quick-release axle protrudes from the axle
hole about 1 cm.
3.
Close the quick-release skewer.
4.
Repeat if necessary.
WARNING
Reattachanypreviouslydisconnectedcables(e.g.lightingcables),
otherwise you could tear them.
3.10.4 Rims
Wear
WARNING
Lookoutfordeepgroovesonbothrims.
The rims could fracture and cause a fall.
Replace rims as soon as you detect signs
of wear.
Many rims have a wear indicator. If it can
no longer be felt at a certain point, the
rim is worn.
Wear indicator
Cleaning
1. Remove the pedelec battery.
2. Brush the rims with a hand brush. Heavier soiling can be removed with
a soft, damp cloth.
IMPORTANT
Whenyouarecleaningtherims,makesurethatnowatergetsintothe
motor. Water ingress can damage the motor.
3. Leave to dry.