Shimano STEPS E6000 - Disposal; Replacement Bulb

Original User Guide | Pedelec Shimano Steps E6000 Version 1 EN-9
IV.II.I.IReplacementbulbs
The replacement bulbs you will need depend on the type of lights tted on
your bike. The table below tells you what type of bulb you need:
Type Power supply
Front light (LED, incandescent) 6 V 2.4 W
Front light halogen 6 V 2.4 W
Rear light 6 V 0.6 W
Rear light with parking light 6 V 0.6 W
Lighting with LED lamps LED lamps are not replaceable
Hub dynamo 6 V 3 W
IV.II.II Disposal
Do not dispose of the drive system, display, easy-
reach control, pedelec battery or charger in the
household waste. Hand them in at the designated
places (such as a recycling centre, battery collection
point or cycle dealer).
Electrical devices marked
with this symbol must not
be disposed of in house-
hold waste.
Lighttype Number Position Characteristics
Rear light 1 Rear Red light
The lowest point of the illuminating
surface must not be lower than 250 mm
above the road surface.
A parking light function is also permitted.
Reector At least 1 Rear Red
The highest point of the illuminating
surface must not be higher than 600 mm
above the road surface.
Large reector 1 Rear Red
The large reector is marked with a Z.
It can be integrated in the rear light.
Reector 2 Per pedal Yellow
They reect light in both directions
(forwards and backwards).
Reector (or
reective wheel
stripe)
At least 2 Per wheel Yellow
Attached to the spokes at an angle of
180˚.
They reect light to the sides.
Reective stripe (or
wheel reector)
1 Per wheel Ring-shaped reecting white stripe.