Original User Guide | Pedelec Shimano Steps E6000 Version 1 EN-33
IMPORTANT
Onlyusethebatterytooperatethispedelec,otherwise there is a risk
of damage to the device.
Batteries are subject to the dangerous goods regulations.
Private users are permitted to transport them on the road
without further conditions. When transported by commercial
third parties (such as by air, freight forwarders and logistics
rms), special requirements of packaging and labelling must
be observed. Please contact your cycle dealer if you have any
questions about transportation.
CAUTION
Batteriesmustnotbeimmersedinwater. This presents a risk of
explosion. Do not extinguish a burning battery with water, only the
surrounding burning material. Fire extinguishers with metal re
powder (Class D) are more suitable. If it is possible to take the battery
safely outside, smother the re with sand. But you need not be afraid
of the battery exploding under you when you ride the cycle through
rain. The battery is sealed to prevent moisture and spray water from
entering.
IMPORTANT
Batteriesmustnotbesubjectedtomechanicalimpact. This poses a
risk of damage. A battery can still be damaged after a drop or impact
even if there are no visible signs of damage. A battery which looks ne
on the outside should therefore also be subjected to an inspection.
Please contact your cycle dealer.
Performa‘learningcycle’:A new, fullycharged battery should be
run down once until the motor assist stops and without recharging in
between. In that way the battery ‘learns’ its capacity, and the actual
capacity will agree with the level indicated on the battery status
display. As soon as the battery enters Sleep mode, press the battery
button for one second. Then the learn cycle can be continued. Please
perform a learn cycle every six months or 5,000 kilometres. When the
battery becomes older and you do not repeat the cycle from time to
time, the dierence between actual battery capacity and charge level
display will become greater and greater.
To Next Page
Loading...
