Shimmer 3 - Agency Compliance; FCC

To Next Page

To Previous Page

Realtime Technologies Ltd Shimmer User Manual

iii

Agency Compliance

FCC

Contains FCC ID: X2W-SR7-1

The FCC ID marking label is attached to the back of the Shimmer and is to remain attached at all times to

comply with FCC requirements for Modular approval:

Here is an example of the text on the FCC ID marking label:

Model: Shimmer 3

Contains: FCC : TJ-RN42

IC : 6514A-RN42

BT RADIO ID:

Made in Ireland

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired

operation.

RADIO AND TELEVISION INTERFERENCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and the receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Changes and Modifications not expressly approved by Realtime Technologies Ltd. can void your authority to

operate this equipment under Federal Communications Commission rules.

ICES-003 Label

Other manuals for Shimmer 3