Table 3: Symbols for operating modes
Icon Description
The device is in “measured value display” operating mode
when it is switched on. The RUN symbol and the current dis‐
tance value are displayed. This operating mode enables you
to display other process values.
The MEN symbol is displayed in “menu display” operating
mode. In this operating mode, device parameters can be read
out or set depending on the interface.
When it comes to setting parameters in devices with fieldbus
interface, make sure to observe the notes in see "Operation",
page 34.
NOTE
In the display, distance values always have the resolution “mm”, speed values the reso‐
lution “mm/s”. Positive numerical values do not have a sign, negative numerical values
have the “-” sign. This limits the display range to 5 decimal places when numerical
values are negative. In the “measured value display” operating mode, the sign and
the highest decimal place are cut off and replaced by a "!" when the value -99,999 is
undercut.
3.4.3 Operating pushbuttons
The device can be operated using the following 4 pushbuttons:
Table 4: Pushbuttons
Button Description
■
Scroll through process values or (main) menu
■
Reduce value
■
Scroll through process values or (main) menu
■
Increase value.
■
Enter menu operation
■
Switches to the next lower menu level
■
Confirm selection
■
Leave value/option input of a parameter without saving.
■
Jump back to the next highest menu level or to the measured value display.
3 FUNCTION AND USE
16
O P E R A T I N G I N S T R U C T I O N S | DL100 Pro EtherNet/IP 8016994/19HB/2022-03-15 | SICK
Subject to change without notice
To Next Page
Loading...
