SICK DL100 Pro EtherNet/IP - Technical Data; Optics; Performance Data

13 Technical data
NOTE
The relevant online data sheet for your product, including technical data, dimensional
drawing, and connection diagrams can be downloaded, saved, and printed from the
Internet:
•
www.sick.com/DX100
Please note: This documentation may contain further technical data.
13.1
Optics
Table 48: Laser/optics
Light sender Laser diode, red light
Laser class 2 in accordance with EN 60825-1 / CDRH
CW modulation ± 0.85 Po sinusoidally modulated
Maximum peak output ≤ 1.9 mW
Pulse duration 6.8 ns
Average performance P
0
< 1 mW
Shaft Length 655 nm
Frequency ≥ 90 MHz
Light spot size Typically 5 mm + (2 mm x distance [m])
Average service life Typically 100,000 h at +25 °C ambient temperature
13.2 Performance data
Table 49: Performance data
Measuring ranges
•
DL100–21XXXXXX: 0.15 m … 100 m
•
DL100–22XXXXXX: 0.15 m … 200 m
•
DL100–23XXXXXX: 0.15 m … 300 m
Measuring object On Diamond Grade reflective tape DG983
Measurement accuracy
•
DL100–21XXXXXX: ± 2.0 mm
•
DL100–22XXXXXX: ± 2.5 mm
•
DL100–23XXXXXX: ± 3.0 mm
Repeatability
2)
•
DL100–21XXXXXX: ± 0.50 mm
•
DL100–22XXXXXX: ± 1.00 mm
•
DL100–23XXXXXX: ± 2.00 mm
Measurement cycle time 1 ms
Response time/Measured
value age
2 ms
Output rate 2 ms
Initialization time
■
Typically 1.5 s
■
After reflector loss: < 40 ms
1)
The measurement accuracy can be up to ± 4 mm in the 150 mm...180 mm measuring range.
2)
Statistical error 1 σ, environmental conditions constant, minimum warm-up time 10 min.
TECHNICAL DATA 13
8016994/19HB/2022-03-15 | SICK O P E R A T I N G I N S T R U C T I O N S | DL100 Pro EtherNet/IP
77
Subject to change without notice