8 Ethernet interface
There are two equal Ethernet interfaces available on the device. They lead to an internal
switch and are used for communication via EtherNet/IP.
They can also be used for communication via SICK configuration software SOPAS ET
see "SOPAS ET configuration software", page 46.
Each device has its own MAC address. The MAC address can be found on the type label
see "Type label", page 14.
NOTE
You can download the SOPAS ET configuration program online at www.sick.com/
SOPAS_ET.
NOTE
SOPAS ET should only be used for service purposes (e.g. diagnosis, firmware update)
and not for parameterization.
8.1 Features
The Ethernet interfaces have the following features:
•
Transmission rate 10 or 100 MBit, half or full duplex
•
Auto-negotiation (automatic adjustment of transfer rate and duplex procedures)
•
Auto-crossover (automatic adjustment in the case of Ethernet cables)
•
DHCP (dynamic IP address assignment via DHCP server) or static IP address
assignment
8.2 IP network configuration
During delivery or after a reset to factory settings, the following IP network configuration
is set on the device:
•
Dynamic IP address assignment via DHCP switched off
•
Static IP address assignment switched on
•
IP address: 192.168.100.236
•
IP network mask: 255.255.255.0
•
Default gateway: 0.0.0.0
You can change the IP network configuration via the SOPAS ET configuration software.
NOTE
If address assignment using the DHCP server is parameterized and it fails, the last
selected static IP address is used for the device. The delivery configuration is used
if this static IP address is invalid (IP address 0.0.0.0). This process may take up to
approx. 1 minute. If the IP address is 0.0.0.0, the device cannot be found via SOPAS ET.
It may be necessary to reset to factory settings and restart the device.
ETHERNET INTERFACE 8
8016994/19HB/2022-03-15 | SICK O P E R A T I N G I N S T R U C T I O N S | DL100 Pro EtherNet/IP
45
Subject to change without notice
To Next Page
Loading...
