SICK HIPERFACE DSL - Page 28

The acc_thr_err signal can be used to implement a fault-tolerant evaluation in the
drive. For this the maximum position deviation should be calculated from the number of
transmission errors.
5.4.8 ENCODING_ERR signal
encoding_err is a DSL Master digital output.
The encoding_err signal is set if the underlying 8B/10B encoding of a DSL frame
transmission is disturbed.
The encoding_err signal can be used to make a statistical analysis of the bit error
rate of a DSL system.
5 INTERFACES
28
T E C H N I C A L I N F O R M A T I O N | HIPERFACE DSL
®
8017595/ZTW6/2018-01-15 | SICK
Subject to change without notice