SICK UM18-2 Pro - Additional Settings for All Sensors

CongurationOverview
50 © SICK AG • Subject to change without notice • 8014865/ZUJ3/2018-11-29
13.3 Additional settings for all sensors
flashes
Green LED:
Switching between teach-in and
synchronization/multiplex mode
Switch off the supply voltage
Switch on the supply voltage
To change the setting,
apply M at MF for approx. 1 s
Reset to the factory setting
Normal operation mode
Wait approx. 10 s
Wait approx. 3 s until both LEDs
flash simultaneously
Wait approx. 13 s until both
LEDs stop flashing
Further settings
Green LED: stops flashing
Orange LED: changes status
Apply M at MF
Orange LED: on: teach-in
off: synchronization/
multiplex mode
Switch on the supply voltage
Apply M at MF
Before switching off the supply
voltage, disconnect M from MF to
apply the factory setting
Switch off the supply voltage