SICK VMS4200

3 SYSTEM DESCRIPTION
36
8026364 / V1-0/2022-03|SICK
SUPPLEMENTARY OPERATING INSTRUCTIONS | VMS4200/5200
Subject to change without notice
For dynamic scale value switchover, the scale values for two scale interval values used
must be described in two separate information labels. For scale interval value 1, the
dynamic option on the system information label should be marked. The dimension values
with unit of measurement (mm or inch) must be specified in indelible ink. On the
information label for scale interval value 2, the dynamic scale value and the measuring
unit (mm or inch) with the accompanying dimension values must be specified.
The type labels for the LMS4x21 are also affixed to this information label.
The type label for the SIM2000-2 Prime controller must be affixed to the metrology
information label in the appropriate field.
Fig. 23: Information labels for the VMS5200 for dynamic scale value switchover with affixed type
labels
Legend
1 System information label for scale interval value 1
2 System information label for scale interval value 2
3 Metrology information label with affixed type label
Information labels
with dynamic scale
value switchover