Siemens 3RW44 - Page 193

PROFIBUS DP communication module
9.12 Data sets (BS)
3RW44 soft starters
Manual, 03/2017, NEB535219502000/RS-AB/008
193
The following messages can be entered:
Table 9- 22 Messages in the logbook - Reading events
ID
No.
Events - messages
Note
Warnings
324 Temperature sensor overload ± (coming/going event)
325
Temperature sensor wire break
± (coming/going event)
326
Temperature sensor short-circuit
± (coming/going event)
327
Thermal motor model overload
± (coming/going event)
334
I
e
current limit exceeded
± (coming/going event)
335
I
e
current limit undershot
± (coming/going event)
340
Asymmetry detected
± (coming/going event)
342
Ground fault detected
± (coming/going event)
Actions
310
Emergency start active
± (coming/going event)
357
Automatic mode
+ (coming event only)
358
Manual bus mode
+ (coming event only)
359
Manual mode local
+ (coming event only)
360
Connection abort in manual mode
+ (coming event only)
363
Maximum pointer deleted
+ (coming event only)
365
Invalid parameter value
+ (coming event only)
ID No. of incorrect parameter
366
Parameters cannot be changed in ON state
+ (coming event only)
ID No. of incorrect parameter
368
Parameters disabled CPU/master active
± (coming/going event)
369
Factory settings restored
+ (coming event only)
1302 Logbook - trips deleted + (coming event only)
1303
Logbook - events deleted
+ (coming event only)