Siemens 6DD1607-0AA2 - Overview, Manual Mode; Overview, Automatic Mode: Communications

Configuring
Application Module FM 458-1 DP - User Manual 4-57
A5E01078222-02 Edition 03.2009
4.7.1.1 Overview, "Manual mode"
The principle procedure in the "Manual mode" is shown in the following
diagram:
(2)
Activate the
inactive table with
entered values
(3)
Tabular values are
available in the
configured
software
SIMATIC TDC
SIMATIC
FM458
SIMADYN D
T400
XP
YP
IP
YXP
YYP
YIP
TVL
FB TAB or
FB TAB_D
(1)
Individually
enter
tabular values
Fig. 4-30 Principle procedure in the "Manual mode"
A detailed description of the "Manual mode" is provided in Section
"Manual mode" (Page 4-62)
4.7.1.2 Overview, "Automatic mode: Communications"
In the "Automatic mode: Communications", tabular values can be
transferred using the following communication versions:
 S7 via the P bus for SIMATIC FM 458-1 DP (it is necessary to
additionally configure the WR_TAB on the control side)
 TCP/IP (tabular values can be transferred from a SIMATIC TDC
module to another one using the CTV and CRV FBs)
 DUST1 (tabular values can only be transferred via a DUST1 interface)
The tabular values are transferred using data telegrams.
The following diagram illustrates the principle procedure in the
"Automatic mode: Communications" for transferring tables from an S7
control to a SIMATIC FM 458-1 DP application module via the P bus: