Configuring
Application Module FM 458-1 DP - User Manual 4-115
A5E01078222-02 Edition 03.2009
Only the WinCC-relevant information can be taken from the address
book: Data block number and offset of the selected function block
connections.
4.9.1.3 Configuring WinCC
When configuring WinCC, proceed in the following steps:
1. Start the WinCC Control Center.
2. Set-up a new project or open an existing one.
3. Set up the new driver by selecting Tag Management righthand
mouse key Add New Driver SIMATIC S7 Protocol Suite.CHN
Open. If this already exists, then continue with the next step.
4. Set-up a new connection by selecting TCP/IP righthand mouse key
New Driver Connection.
Function chart name
Function block name
Connector names
Data block number (DB), offset
Data type
To Next Page
Loading...
