Siemens 6DD1607-0AA2 - Configuring the CFC; Configuring Wincc

Configuring
4-128 Application Module FM 458-1 DP - User Manual
A5E01078222-02 Edition 03.2009
4.9.3.2 Configuring the CFC
No additional function blocks have to be configured when using the MPI
coupling.
If the DP interface of the FM458-1 DP is to be used, then as shown in the
following screenshot, function block "@PRODP" should be configured in
a task between 32 and 256 ms.
Connector CTS should be connected to interface X3 of the FM458-1 DP
(righthand mouse click on the CTS > Connection to operands > NAME of
the FM458-1 DP.X3).
4.9.3.3 Configuring WinCC
1. Set up the new driver by selecting Tag Management  righthand
mouse key  Add New Driver  SIMATIC S7 Protocol Suite.CHN
 Open.
If this already exists, then continue with the next step.
2. Set-up a new connection by selecting MPI  righthand mouse key
 New Driver Connection.
Tx: 32…256 ms
"Name.Front connector"
of the FM458-1 DP