Product description
2-18 Application Module FM 458-1 DP - User Manual
A5E01078222-02 Edition 03.2009
2.2.3 Supplementary components
All of the I/O signal cables are not directly connected to the module, but
via interface modules. The interface modules are used as mechanical
connecting elements (screw terminals) as well as to electrically adapt the
plant/system signals and convert them (optional).
Components Designation Order No.
Interface module, electrical 1:1 connection SU12 6DD1681-0AJ1
Interface module, electrical 1:1 connection SU13 6DD1681-0GK0
Interface module, electrical 1:1 connection SB10 6DD1681-0AE2
Interface module with electrical isolation and
signal conversion
SB61 6DD1681-0EB3
Interface module with electrical isolation and
signal conversion
SB71 6DD1681-0DH1
power supply connector for interface module
SB10, SB61, SB71
SM11 6DD1680-0BB0
Table 2-7 Interface modules for the I/O expansion module EXM 438-1
NOTE
The operation of the EXM438-1 is only allowed with these interface
modules.
The interface modules are “open type” and therefore only can be
installed in closed switch cabinets or switch rooms.
For further informations about the interface modules see documentation
“SIMADYN D Hardware”
The module is connected to the interface modules via the appropriate
plug-in cables. Plug-in cable SC62 has five cable ends which can be
connected to the appropriate number of suitable interface modules.
Components Designation Order No.
Connecting cable, 50-pin/5*10-pin SC62 6DD1684-0GC0
Connecting cable, 50-pin/50-pin SC63 6DD1684-0GD0
Table 2-8 Cables for the input/output expansion module EXM 438-1
Interface modules
Cables
To Next Page
Loading...
