Configuring
Application Module FM 458-1 DP - User Manual 4-81
A5E01078222-02 Edition 03.2009
Fig. 4-48 Contents of the newly generated DB in the "LAD/STL/CSF" application
4.7.3.3.3 Subsequently downloading tabular values into a DB
If tabular values are to be subsequently downloaded into the DB,
because the table is too large and there is not sufficient user memory for
several DBs, then the table should be transferred to the SIMATIC FM
458-1 DP application module in several sub-sets of the table. To do this,
the table must be split-up into sub-sets of the table. The size of the
individual sub-set tables should be selected so that the user memory of
the S7-CPU is not exceeded. The individual table sub-sets are then
transferred one after another.
HINWEIS
It is especially important that the individual table sub-sets are
transferred in the sequence of the value pairs. If they are transferred in
the incorrect sequence, then the tabular values will not be correctly
available in the configured software.
To Next Page
Loading...
