Configuring
4-100 Application Module FM 458-1 DP - User Manual
A5E01078222-02 Edition 03.2009
4.8.1.3 Status-dependent parameter changes
If selected parameters are only to be changed when the system is in
specific statuses, then you can configure the following functions blocks:
Function block PSTAT
to configure a device status
by entering a password with the authorization level enabled
Function block PLIM
defines the statuses and access levels in which a parameter may
be changed
Additional information
on function blocks, refer to the Reference Manual "SIMADYN D Control
system, Function Block Library".
4.8.1.4 Identifying SIMADYN D components
To identify components, “DRIVE Monitor“ evaluates technology
parmeters d998 (1998) and d999 (1999).
d998 Device Special feature
80 SIMADYN D,
general
The parameter range, especially extended for SIMADYN D up to 16 *
2000 parameters, applies.
Parameters are possible in the basic device parameter range (0 ..
999). This means, an identification can result in a random product if a
parameter just by chance coincides with the identification parameter
and value of a drive converter/inverter.
134 T400 / Parameter range = technology parameters
(1000 .. 1999; 3000 .. 3999)
134 FM 458-1 DP/
SRT400
Parameter ranges, the function can be set at the central FB
BASEBOARD: 0 ... 999; 2000 ... 2999
TECHBOARD: 1000 ... 1999; 3000 ... 3999
Prerequisite: The user selects SIMADYN D or SRT400 and goes online
with the device type.
Dependig on the selected device type, DriveMonitor checks the
identification parameter d998. If the identification was successful, it is not
checked as to whether another device can be recognized.
1. User selects SIMADYN D: If d998 = 80, then the identification routine
is considered to have been successful.
Reserved
parameters
Procedure when
identifying
To Next Page
Loading...
