Siemens 6DD1607-0AA2 - Generating the Hardware Configuration; Functional Scope

Configuring
4-106 Application Module FM 458-1 DP - User Manual
A5E01078222-02 Edition 03.2009
4.8.2.3 Generating the hardware configuration
You require the following hardware to parameterize the
SIMATIC FM 458-1 DP modules:
 Subrack for S7-400
 Power supply module for the S7-400
 Central module (CPU) for S7-400
 FM 458-1 DP application module for SIMATIC S7-400
 EXM 448 communications-expansion module
In HW Config, the "Communications" plug-in module type must be
activated for the properties of the EXM 448.
 CBP2 communications module (COMBOARD)
4.8.2.4 Functional scope
You must configure the following function blocks when parameterizing
with “DRIVE Monitor“:
 Central block @FMPAR
 monitors the COMBOARD
 processes the parameter tasks
 Function block CBCONF
 used to configure a COMBOARD
 used to display the diagnostic data of a COMBOARD