Configuring
Application Module FM 458-1 DP - User Manual 4-79
A5E01078222-02 Edition 03.2009
After the file has been opened, it can be edited in the "LAD/STL/CSF"
program. There it can be compiled via "File / Compile".
The procedure is shown in the following diagram:
Fig. 4-46 Compiling the source file in the "LAD/STL/CSF" application
After the file has been successfully compiled, a new DB is available in the
configured software. The name of the DB corresponds to the name
specified in the header line of the file.
The following diagram illustrates the newly generated DB in STEP7
configured software under "Blocks":
To Next Page
Loading...
